VETUS Equipment
VETUS VDR Propeller Shaft Drives
VETUS VDR drives combine a self-aligning thrust bearing with a double-acting constant velocity joint, allowing softer engine mounts; up to 24,000 N thrust, for 25–70 mm shafts.
Description
The VETUS DRIVE (type VDR) combines a self-aligning thrust bearing and a double-acting constant velocity joint between engine and propeller shaft. Propeller thrust is taken by the built-in thrust bearing, so the engine can sit on softer mounts, reducing vibration and transmitted noise.
Technical data
- Maximum thrust up to 24,000 N
- Black passivated steel and high-performance rubber
- VDR2 and VDR4 – shaft diameters 25, 30, 35, 40, 45 or 50 mm
- VDR6 – shaft diameters 50, 60 or 70 mm
- Constant-velocity joint sizes 21, 30 and 42; 4", 5" or 6" flanges
- Interchangeable with other well-known models
More from VETUS
- VETUS Electronic Remote Controls ECS
- VETUS Shaft Seals and Flexible Inner Bearings
- VETUS Anti-Siphon Air Vents
- VETUS Bronze Stern Tubes
- VETUS Cooling Water Strainers
- VETUS Duplex Stainless Steel Propeller Shafts
- VETUS Electric Propulsion Controls
- VETUS Electronic Engine Remote Controls EC3/EC4
- VETUS E-LINE and E-POD Electric Propulsion Motors
- VETUS Energy Storage for Electric Propulsion
- VETUS Energy Supply for Electric Propulsion
- VETUS Exhaust Goosenecks
Featured products
All products →
Equipment
8DZ DF genset
ABC 8DZ dual-fuel genset: medium-speed 8-cylinder inline engine running on natural gas (CNG or LNG) with diesel pilot ignition, or on diesel at any time; low-pressure gas supply up to about 500 mbar.
Equipment
Flaig FX Lift Magnets
Flaig Magnetsysteme lift magnets, offered by IMI under an exclusive North American partnership, for flat, angle, thin-sheet and cylindrical parts.
Component
Bolts, Nuts and Studs Made to Order
Special bolts, nuts and studs made to order in any metal, alloy and class, including turbine bolts and Duplex / Super Duplex stud bolts.
Similar products